A fixed five-axis reciprocating machine equipment
In front of each device has two base angles are two good wire-tapping fixing holes. You can choose what way to fix the equipment:
1, cut a piece of angle iron, then use screws to secure the explosion on the ground
2, mounted to a base angle of the floor fixed device
3, the device welded square pass on.
Second, check the five-axis reciprocating machine equipment components
1, is connected with the linear guide module by Allen screw and counter nut to complete, each track consists of 3-5 M6 screws to complete the connection of the track. Wherein X, Y axis are the same structure, so check time not to have any oversight.
2, synchronous wheel and connected to the output shaft
Synchronizing wheel and the output shaft are a tight fit way to connect, and a pin which is embedded between the key and use the screws tightened, while the locking screws are tight seal glue plus
3, the overall module is connected with the frame, the overall use of the flange plate with the rack with screws and tighten the connection.
Three, five-axis reciprocating machine lubrication equipment
1, because the device is a mechanical movement, so in order to extend the life and reduce the noise, the need for this equipment lubrication
2, please lubricate the device when the appropriate choice of oil, we recommend the use of high-temperature solid lubricants.
3, to lubricate the device, using the appropriate a gun.
4, note: the Z-axis guide rail within the cumulative use of more than one month after the need to disassemble the dust cover for lubrication.
Four, five-axis reciprocating machine considerations
1, because the device is a mechanical movement, the equipment is energized, disabled access within the frame of the device.
2, the device is powered down the need to adjust the size of the fuel spray gun, do pay attention to their own safety.
3, the training time for new employees to do the attention to the operational safety training.
4, the bottom of the wheel well, there have been electrical torque limit, should pay attention to safety, to avoid being linked to the wounded.
This article posted by Xin Qinfeng industrial equipment finishing.