Gun maintenance and troubleshooting advice
A note:
1. Each time the work is completed, should be carefully cleaned the paint passage, each painting is a hole nozzle and air cap. Cleaning hood or nozzle holes, prohibited the use of hard copper wire poke. (Eg: paper clips, pins ...)
2. The non-invasive whole gun cleaning solvent, in order to avoid solvent into the gun air ducts, causing damage to the gun. Spraying pressure is too low lead paint orange peel, serious adverse atomization.
3. The pressure is too high will produce coating "dry spray" phenomenon, the film gloss or reduce the adhesion of paint drops, it will produce uneven fogging phenomenon. (Spray paint across the web more than the middle part, it is often said: starting from the pole to the other phenomena).
You should check the fastening member 4 after each job or money cleaning. Lid to save the gun air vents, or the flow of goods lead paint small.
5 grab the tail of the intake air compressed air leaks occur connector, the same specifications should be replaced immediately air connector, prohibited the use of paper tape or other types of objects replacement seal tape to avoid debris from entering the air duct gun. Causing blockage.
Gun clean up the demolition of small wonders
Second gun deep cleaning program:
a. Removing air cap nozzle firing pin three-piece order:
First split needle - air cap - nozzle. The three-piece then soaked into the solvent cleaning, prohibited the use of hard copper wire poke. Be cleaned with a soft tool.
b. Gun to wipe clean with a clean cotton stick right amount of solvent. Whole gun is prohibited soaked solvent cleaning to avoid the solvent into the gun air ducts, causing damage to the gun.
c. After the above process is complete, three-piece hood striker nozzle installation sequence:
First split needle - air cap - nozzle contravenes installer easily lead to the phenomenon of the nozzle split up, then check the fastening member can
2 Gun simple cleaning procedures:
a cleaner solvent into the paint cup, access air spray until a clean solvent can be discharged, and then remove the air cap invade solvent. Scrub brush and clean the orifice hood, hood ensure unobstructed aperture can be.
b gun to wipe clean with a clean cotton stick right amount of solvent. Serious whole gun soaked solvent cleaning to avoid the solvent into the gun air ducts, causing damage to the gun.
PS: If nozzle clogging can not leak into the spraying should be handled according to the depth of spray cleaning procedures. Thanks for your support.
Shenzhen Xin Qin Feng Industrial Equipment Co., Ltd.